hi - i have vu+duo2 with BH 3.0.3 image, currently using mgcamd1.38 as a client, trying to set up oscam as a client but struggling , which one do i need from this thread here and how do i do it ?,i have no problem with mgcamd1.38 but get constant glitching and freezing , was told by my provider to try oscam but no help in how to do it or install it..thanks
Convert mgcamd to oscam on vu+ duo2 black hole image
-
- MIPS OSCam
- raymondffloyd
- Thread is marked as Resolved.
-
-
Install the attached oscam.
Use mgcamd2oscam to convert the CWS line to a reader -> Camsconverter, cccam2oscam, mgcamd2oscam
Add the reader to oscam.server, which can be found in /etc/tuxbox/config
-
thanks working fine...gonna monitor it see how it goes....
-
thanks master G for your help got oscam working, but still getting glitching and freezing every few minutes, must be a rubbish server. Ecm times are very high ,from 2000ms to 8345ms at one point..:(
-
Did you remove the values from the reader i suggested on the mgcamd2oscam link ?
Unstable ecm time can also be a problem at your end, like you are downloading, gaming, using a lot of bandwidth, using wireless / homeplugs.
If removing those oscam values don`t help and you know there is no issue at your end it will be a problem with the server.
At least you have ruled out its not a problem with mgcamd or oscam.
-
you mean delete like this below or change the values to 0?
inactivitytimeout
reconnecttimeout
lb_weight
cccversion=2.1.2
cccmaxhops
cccwantemu
ccckeepalive=1
-
hi ive converter mgcamd line to oscam ftp the files to ect tubox config started oscam but line not clearing just got blank screen any help much appreciated got it all working now
OSCam Support Forum
Configs, discussion, downloads and guides for OSCam Softcam.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!