Why with NCAM installed on my ZGemma with Italysat i cannot see these panel
[img]https://i.imgur.com/hhF1IcL.png[/img]
on NCAM control.
I see this only if i set oscam...
So mean that emu not run or ?
Thank
Hispa
There are 6 replies in this Thread which was already clicked 1,133 times. The last Post () by hispanico957.
Why with NCAM installed on my ZGemma with Italysat i cannot see these panel
[img]https://i.imgur.com/hhF1IcL.png[/img]
on NCAM control.
I see this only if i set oscam...
So mean that emu not run or ?
Thank
Hispa
becasue of the ports assigned to oscam or ncam
try 8888 for oscam
ip.of.your.box:8888
and for ncam 8181 or 8080 or 81
to find the correct port you can try to opening oscam.conf or ncam.conf
Display Morebecasue of the ports assigned to oscam or ncam
try 8888 for oscam
ip.of.your.box:8888
and for ncam 8181 or 8080 or 81
to find the correct port you can try to opening oscam.conf or ncam.con
Yes thank i know but in anyway when selct NCAM idont see all logs and cw....
Thank
Hispa
the picture you attached was ncam webif with logs
now what's the problem ?
if you want to see constant.cw on webif then you should add reader to ncam.server like these
[Reader]
Label = constant.cw
Protocol = constcw
Device = /etc/tuxbox/config/constant.cw
Caid = 2600,0B00,0500,0963,06AD
Ident = 2600: 000000; 0B00: 000000; 0500: 032830; 0963: 000000; 06AD: 000000
Group = 1
then you can see on webif and edit your address of cw
welcome
I follow your istructions but no logs of cw on panel
Hispa
if you have correct CAID for Channels on reader and Correct Code on cw or softcam
then you should see this log for your channel on webif
017/12/29 02:49:00 4F185EFA c (ecm) dvbapiau (2600@000000/0000/0067/0B:D957CEA795E0960B30D5AAB3E6F7F054): found (3 ms) by constant.cw
and this line for Softcam.key if you addressed the reader to /etc/tuxbox/config/Softcam.key
I must select some set on reader to see logs ?
Thank
Hispa
Don’t have an account yet? Register yourself now and be a part of our community!