Hi, I have purchased dm920 and wonder which images and are easy to use for a beginner:hello
Help DM920
- sork64
- Thread is marked as Resolved.
-
-
SatLodge Image.
-
I never tried SatLodge possible it`s fine for start,
I have my 920 like 6 months at this point I`m using Pure2 6.2 (latest one) - I like this one !
-
hello
how can i flash new image for my dm900 uhd and wiitch is best?
-
1.) Turn on the power switch of DM900 at the back
2.) If LED on the Standby-Button at the front lights up, keep it pressed until LED quickly lights up red and blue
3.) When LED stops blinking then release Standby-Button
4.) After few seconds a info shows up on TV, that DM900 is in Rescue Mode
5.) You have to enter via browser -> “http://dm900” / “http://dm900” (without “” ) or IP-Adress of DM900 which is shown on TV
6.) You will see Rescue Mode of DM900 . Click “Firmware upload”
7.) Now click “Select File” and then choose image for the DM900 and after that click “Select”
8.) Next you have to click “Go!” and DM900 starts with flashing
9.) After flashing click on “Click here to reboot” and wait until DM900 is rebooting
-
hello
thanks for reply but the link that showen not working do i do wrong or somthing?
help
-
enter via web browser IP-Adress of DM900 which is shown on TV, when Dreambox is in Rescue Mode
-
hello again
thank you for support i managed yo flash the dm900 but i couldn't find any cccam emu
and what's is work with dm900 is it cccam or oscam?
thank you for help
-
It works with Oscam
-
https://m.mediafire.com/folder/p0hyt9w5cq4d9/pli-extras
Here you can find the best image from pli for your DM920
-
sorry i used openli
-
thank you all it was useful info i got from you keeping in touch
one thing only how can i put my line info on oscam?i couldn't find the emu
.
-
sorry to take your time i wan't to add my line i don't know how to do it
pleas help i wan't to add it on oscam
sork64 can you help me to set up my acount on oscam i tryid many time
but i didn't managed to do that
i am thankful for your effort
hi i think you have to ask somebody who is better than me, i'm a beginner too.:)
-
Works with CCcam 2.3.1 and 2.3.2, check for ARM version
Emo
-
emosim do you know something about add acount on cccam or oscam?
and thank you
-
do you know something about add acount on cccam or oscam
For CCcam, just add the c line to the CCcam.cfg and send to folder /etc on the receiver.
For oscam, convert c line to a reader with this tool -> Camsconverter, cccam2oscam, mgcamd2oscam. Add reader to oscam.server. Use attached oscam configs. Send all files to /etc/tuxbox/config/oscam (assuming you are still using openpli image).
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!