iS there a way to show only my local card and not client card too
in oscam user i give to all client group = 1 (my local)
but client see other card ...fortunatley without share
where have i to configure oscam ?
really tanks
HOW TO SHOW ONLY LOCAL CARD
- ulucini
- Thread is marked as Resolved.
-
-
If assign diffrent groups to your shares like local card is group 1 and remote card is group 2
then do the same with users. Assigning them to group 1 will give them access to local card only
since they are not member of group 2.
If you want to add 1 user to both group then edit user and assign group number with comma ex: 1,2
then that user will have access to all readers (Shares)
-
i have that configuration !!! my local is group and clients share only my local ....but they see i have other cards...
sorry for my english
-
There are a lot of ways of filtering. Oscam is in this case one of the best Softcam (for filtering).
It is possible to filter specific "services" (channel table) you specify in the "oscam.services" file. Then, you will use these channel tables under the "reader" section of the "oscam.server" file or even under the "accounts" in the "oscam.user" file. You can also include an exclamation mark before the group name, which means inverse access to this channel table.
http://www.streamboard.tv/wiki…/en/Config/oscam.services
http://www.streamboard.tv/wiki…onfig/oscam.user#services
http://www.streamboard.tv/wiki…fig/oscam.server#services
It is also possible to filter the entire CAID (the entire satellite provider) for a particular user. You just need to add a caid = XXXX to "oscam.user". In this case, the CAIDs should be identified under all "readers" in the "oscam.server" file to avoid unnecessary problems.
http://www.streamboard.tv/wiki…en/Config/oscam.user#caid
User groups leading to readers are not very effective when using cccam protocol. Groups just say if the user can use the reader. Not whether he can even see the reader. All CAIDs will always be visible on the cccam server. However, you can take advantage of the user's limitations on a particular CAID as I wrote above. Newcamd is better in this case CAIDs filtering.
There are a lot of filtering options and combinations. You have to study more :).
-
tanks i'll try to read something..... i'd like to give only access(it'ok) and visibility(not ok) to my local caid 183E tivusat. i understand it's not easy with cccam ... i read somewhere that using newcamd is like to much access of the local card....
-
Its the other way around Cccam is almost impossible to filter.
I think that only reason people is using Cccam is because its easy to setupWith Newcamd you have to setup 1 port for 1 caid
example portconfig
portnumber@caid:ident
so for a Conax card this would look like this if we use port 34000
34000@0B00:000000
For multiple cards/CAID just add another port and give client another N line to that port
Example multiple card Newcamd
34000@0B00:00000;34001@0500:043800
and the n line in cccam client would look like this
N: <ip adress to oscam server> <port> <username> <password> 01 02 03 04 05 06 07 08 09 10 11 12 13 14
Hope this explains better to you and just ask away if you need more info
-
reading in internet i realized necamd is to give only to parents...... if you give newcamd to a client exper is like the card is not yours but of him..
sorry my english
OSCam Support Forum
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!
