Hello
I've got GigaBlue trio 4k with Teamblue 6.3 image
No Oscam yet
Wich Oscam and maybe image could I get to watch powervu as well as other encryption such as Biss
Could you ease give me instructions?
Thanks
There are 7 replies in this Thread which was already clicked 2,529 times. The last Post () by mynameisraj786.
Hello
I've got GigaBlue trio 4k with Teamblue 6.3 image
No Oscam yet
Wich Oscam and maybe image could I get to watch powervu as well as other encryption such as Biss
Could you ease give me instructions?
Thanks
The attached oscam is configured for powervu and biss.
Find your keys here ~ Softcam Keys
Some plugins that may interest you are here ~ Enigma2 Softcam Plugins
All the instructions you need are already here, you just need to read a little. If you don`t understand something ask a specific question.
Thanks a lot
Hello
I disturb you as I'm trying to use Oscam you sent me without success
The think is (in my opinion) that I don't have a softcam startup plugin or something like that
In fact I don't have plugin to run or stop Oscam
I tried to install a few of them:
. Tspanel doesn't see Oscam
. The plugin named "Softcam startup" for gigablue teamblue I found on other site Isn't a jpk plugin. I tried to put files directly on decider and I can see it and Oscam can be seen by such plugin. When I tried to run Oscam the plugin blocked. I switched off decoder from the rear and it didn't run anymore... I had to reinstall image..
. Softcam universal plugin is not running on the decoder
At the moment I cannot connect decoder to Internet as I don't have the USB antenna required by trio 4k
So I have to get sw and plugings in the OC and using Ftp to the decider
Di you have any hints with my problem?
Thanks
YOU MAY INSTALL SOFTCAM SETUP PLUGIN VIA SATVENUS PANEL FOR SHOWING CAM STARTING SWITCH.
Hi everyone
I ve got a problem with softcam setup and Oscam
Finally I got aerial to connect wireless and I downloaded softcam setup from pluglins
I installed "enigma2-softcams-oscam-all-images_11.532-emu-r797-arm+mips_all.ipk" without problems
Using softcam setup I choose Oscam and then restart... And the decoder went on a loop with the box "waiting..."
I full reboot and now is stuvked
I have to reinstall software from the pen driver
Could you help me?
What is happening?
Maybe is Oscam file not good for Trio?
Hi
Do you have any hints?
I m thinking to install openatv 6.3 to solve the issue
same problem with me , when when oscam installed , box hang up and could not boot.
Don’t have an account yet? Register yourself now and be a part of our community!