can't find the thread.....Mario config for pv providers. I'd like to read it.
Help to open Powervu channels (SIS on 4.8E)
-
- PowerVU Support
- @str01974
- Thread is marked as Resolved.
-
-
-
master G
Added the Label Powervu Oscam-emu Support -
thanks gorski :)
-
Just realized that i omitted to mention an important piece of info - in the past, i was able to open the AFN channels - so that makes me wonder why the rest of the powervu channels dont open (and they never did)
Formuler F4 turbo
Openpli 7.2
-
Ask your manufacturer for good drivers...
AFN is not opening ATM, for quite a while now...
All the rest seem to be working, like Diva on 4.8E etc.
-
there are two different types of powervu ( des and csa)
afn (and inthe long past a few channels in 4W) were in the easy system type of powervu, which was working in most receivers. the other providers.
so. the most important thing is to find someone which using the same receiver, to confirm if your receiver support it direct, or not...
in other way, you can try the stream relay method...
-
I finally managed to have all powervu channels up and running, not with OSCAM- emu but NCAM (mips_V10.8-r0) - so the issue was surely with the client compatibility.
I thought i'd update this thread in case , other folks are facing the same issue.
-
ncam and gcam are just cloned oscam (and closed source ) versions, which the big difference was support for french tnt cards (a secret api key maybe?)
i do not have the receiver to test myself, but i am sure that if it works in ncam, than it works in oscam-emu too...
-
yes the conf files are similar - but maybe by pure luck, i managed to get the perfect configurations under ncam to have those channels opened.
OSCam-EMU Support Forum
Configs, discussion, downloads and guides for OSCam-EMU Softcam.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!