Advice when using U-boot in spark boxs
Where I found a topic about U-boot in the forum
We thank the owner of the topic, but be careful in dealing with the topic of the U-boot, because it can damage the device in case of wrong use or use without the need for it
Of course Some understood the U-boot wrong
The U-boot is used if the device is completely dead and passed through the JTAG
Then the device takes off on the boot mode, and then it can be resurrected with soft-rescue a suitable one soft rescue 7111 or 7162 Depending on your processor
Most of the brothers whose devices stopped on boot They updated the U-boot this is a mistake
As long as the device appears on the screen of the device Boot meaning that the device originally does not lose the U-boot or boot loader it is the Valid
And the device does not lose the U-boot or boot loader without the result of damage to the flash or charging the flash with a different dump
When a word boot appears on the device First try this solution
Close the device from the power button in the back and Click on the ok from the front of the receiver for 5 seconds, then not leave ok, and
open the device from power button in the back,Until it Appears on the screen is forc supported you from Ok, then you Click on the channel buttons next to it until the word spark appears on the Ok wait a little while Boot appears and the device will run.
As it did not respond So it needs a suitable rescue soft 7111 or 7162 Depending on your processor