1.2.58-rescue-image for Spark processor 7162 all types
This software is suitable for all types of Spark, under the condition of processor 7162
After unzip the attached file, transfer the file named Spark to the usb
Make sure that the folder is not inside another folder, and there is no any Foldr it except Foldr Spark only.
use kingston or sandisk usb 4 or 8 GB
Follow the steps carefully and try more than once Do not give up This file was presented by the professor master G
- Now another important factor is when using the rescue image, you must use the rear USB port, not the front.
- CREATE a folder on your desktop and call it spark
- UNZIP the spark rescue image.
- UNZIP userfsub.img.tar.gz & “mImage.tar.gz files.
- Now place the "mImage" and the "userfsub.img" files into the "spark" folder (Not userfsub.img.tar.gz & “mImage.tar.gz).
- FORMAT your USB Pen Drive in FAT32, DO NOT choose the quick format as it will not work
- TRANSFER the "spark" folder onto the USB Pen Drive
- SWITCH off the receiver at the rear and insert the USB Pen Drive
- PRESS and HOLD the OK key at the front of the receiver and switch it back on at the rear
- FORC will appear on the display after a couple of seconds
- PRESS the RIGHT key FACT should appear on the display
- PRESS OK key
- YOU should now see U LD flashing on the display
- WAIT a good 10 Minutes for the receiver to be back to original factory state (some information on the internet claims that the restore process takes about five minutes, I left mine a bit longer and it worked, so be patient)
Added to our supervisor's professor master G comments above
- Rescue Soft must be installed while you are on the Spark system, not a system enigma2 Until it is accepted
- It is possible not to accept Soft Rescue from the first times, meaning that you repeat the process once, two and three until it ends and the receiver accepts the software even if it did not succeed. Download another copy of Softrescue until you succeed, God willing,
After installing Soft Rescue &successfully solve the problem You can install The appropriate software for your device
