This topic is an update of the Mister G topic below, but with a more recent version, it has more capabilities As the topic was closed, research cannot respond
1 IMPORTANT
a Microsoft DotNet Framework 4.0 is required.*
b. Partitioned and formatted USB flash drive is required.*
c. The configuration of multiboot is possible, but only from E2/Neutrino. It does not work out of Spark.*
d Mulitboot Since version 0.8 also works with USB-connected hard drive port.*
2 configuration:
a start program.*
b. Press on the "configuration" (Configuration).*
c. Select "Amiko Alien." (For all Spark 7111-boxes) or "Spark 7162" in the drop down list*
d Set the IP address.*
e Set password.*
f Save Settings*
g End Program
3 Image instalation:*
a."Extract Image partition on" (Extract image on partition) Select.*
b. Select the USB drive from the drop-down list.*
c. The partition table should be filled in automatically if the partitioning* Check the USB flash drive (see 1.b)*
d set for the partition to be used, as follows:* i - the name (label)* ii. - Than EXT2 file system*
e Verify that the option "Format the partition always unpack before the image"* (Always format partition before extracting image) is activated.*
f "Image Extract" (Extract image) select.
4. Mulitboot Configuration:
a "multi-boot manage" select (manage multiboot)*
b. "Read" (Read) Select.*
c. If the program detects that runs a Spark Image, the configuration* Options are disabled.*
d To add a new position to multiboot set, the name in a field near* the partition number and press "add" (add).*
e In order to activate the image of a given partition, "Enable Image" (Activate image)* and then select start the box again.*
f If the image does not boot from USB, it could not be properly extracted.
program j00ztalator 2.4
To install copies of enigma2 with an extension tar.gz On the external flash through the computer &Access to any copy on
external flash Provided that the computer and the receiver are on the same router & format the flash with more than one extension, and you can also split the flash by program CreateMini Located inside the program
The flash must be format ext3 or ext4
These are the devices supported by the program
After writing all the required data shown in the image, we click Save
With the second option, we proceed to install copies
And the third choice Access to any copy on external flash
You can format the flash with more than one extension, and you can also split the flash by program CreateMini Located inside the program
With the second option, we proceed to install copies
From here, you can install copies with an extension tar.gz
And the third choice Access to any copy on external flash
From here you can cross over to any version on the external flash
