Truman primier 1+ spark sti 7111- rescue-image-1.2.65
First, remove any external flash that is installed on the device
Second, start with this solution and implement what is contained in it
Close the device from the power button in the back and Click on the ok from the front of the receiver for 5 seconds, then not leave ok, and
open the device from power button in the back,Until it Appears on the screen is forc supported you from Ok, then you Click on the channel buttons next to it until the word spark appears on the Ok wait a little while Boot appears and the device will run.
As it did not respond So it needs a suitable rescue soft
This file was presented by the professor master G
Follow the steps carefully and try more than once Do not give up
- Now another important factor is when using the rescue image, you must use the rear USB port, not the front.
- CREATE a folder on your desktop and call it spark
- UNZIP the spark rescue image.
- UNZIP userfsub.img.tar.gz & “mImage.tar.gz files.
- Now place the "mImage" and the "userfsub.img" files into the "spark" folder (Not userfsub.img.tar.gz & “mImage.tar.gz).
- FORMAT your USB Pen Drive in FAT32, DO NOT choose the quick format as it will not work
- TRANSFER the "spark" folder onto the USB Pen Drive
- SWITCH off the receiver at the rear and insert the USB Pen Drive
- PRESS and HOLD the OK key at the front of the receiver and switch it back on at the rear
- FORC will appear on the display after a couple of seconds
- PRESS the RIGHT key FACT should appear on the display
- PRESS OK key
- YOU should now see U LD flashing on the display
- WAIT a good 10 Minutes for the receiver to be back to original factory state (some information on the internet claims that the restore process takes about five minutes, I left mine a bit longer and it worked, so be patient)
Added to our supervisor's professor master G comments above
- Rescue Soft must be installed while you are on the Spark system, not a system enigma2 Until it is accepted
- It is possible not to accept Soft Rescue from the first times, meaning that you repeat the process once, two and three until it ends and the receiver accepts the software even if it did not succeed. Download another copy of Softrescue until you succeed, God willing,
