Update properties after replacing dvbapi, service, srvid, srvid2.

There is 1 reply in this Thread which was already clicked 3,408 times. The last Post () by s3n0.

    Could someone please advise me if I am correct in thinking that I need to update the properties of dvbapi, service, srvid, srvid2 in winscp all to 755 after replacing existing files with the new ones?


    ferez

    Hello.


    Files "oscam.srvid" and "oscam.srvid2" are used to better identify channels in OscamWebif - so you will see the channel name (ServiceName) instead of the channel code (ServiceID).


    However "oscam.srvid" should be up to date. Download it here: http://kos.twojeip.net/

    Oscam creates the "oscam.srvid2" file itself from the available information about each switched channel (reading info from DVB transponder), but only if you enable this feature in the "oscam.conf" file - . He would not have to rewrite. Have Oscam create it automatically (if you allow it of course).


    The "oscam.dvbapi" file is used to filter CAIDs / PROVIDs or create a redirect to another CAID. It depends on whether the entire Oscam is configured correctly.


    The "oscam.service" file contains only channel group definitions, which you can then use as a filter or as an exclusive channel group (used in the "oscam.server" or "oscam.user" files).


    More info about oscam config files:

    http://www.streamboard.tv/wiki/OSCam/en

Your resource for OSCam softcam

Find configs, downloads, tutorials, and support for setting up and optimizing this open-source card server with wide protocol compatibility. Master the versatile OSCam softcam. Access support, configs, tutorials, and downloads for open-source card sharing and multi-protocol server management.