plz help i get weak signal on sparl and engima2.
I test other receiver all ok
Why
Weak signal on spark and engima2
- wida
- Thread is marked as Resolved.
There are 13 replies in this Thread which was already clicked 1,022 times. The last Post () by ahmed gazye.
-
My friend / wida
as long a weak signal on spark and engima2.
Check first
Satellite Dishes / DiSEqC / LNB's / Cable
They can be flawed by the influence of atmospheric factors
Good luck
-
My friend / wida
1. Check the capacitors that have some bulge and especially 220uf 470uf and change them
If the device is sound and there are no capacitors that have some bulge clean the device of dust
2. Open the device cover and clean it with compressed air & Asbari for cleaning electrical appliances
3. Make an update for a file satellites xml By extension etc / tuxbox Then delete all channels and do a new search for the channels
-
My friend / wida
3. Make an update for a file satellites xml By extension etc / tuxbox Then delete all channels and do a new search for the channels
-
My friend / wida
Download the attached file and after unzip it, transfer it by a program DCC to the extension etc / tuxbox and agree to replace it
Then delete all channels and do a new search for the channels By choosing to delete the channels when searching for a new satellite
-
My friend / wida
What is the status of the signal now?
After all of the above
Do you Still weak would be the defect of the tuner or transistor around it
-
Dear brother Ahmad
I have Startrack 2020 HD plus (7162 chip) running in spark mode and also E2 ( openpli 7.0 rc)
My box have issue with scanning horizontal and vertical polarities together
It receives H or V only one polarity at a time
I have shown it to the technician , and he says its IC which splits H and V is not working
It is needed to be replaced , but new one is not available in market
Can you help me to fined any solution , plz tell me detail about this ic (its number etc)
and if someone knows about its replacement plz help
-
Dear brother / iftikhar152
First, I am not an engineer or a technician
try the receiver at a friend until you are sure that the device is defective not at Satellite Dishes / DiSEqC / LNB's / Cable
But it is clear that the defect in the tuner or transistor around it must be sent to a specialist technician to change
what is needed
If he has a other tuner, it is better to change it
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!
