Zgemma h9 combo blocato led rosso

There are 10 replies in this Thread which was already clicked 1,539 times. The last Post () by zorro71.

  • that I know recovery is not there....

    there is a guide for flash


    here she is


    flash procedure x H9.2H


    - Use the FAT32 formatted USB stick - Send the h9 folder and the 2 files (bootargs. Bin and fastboot. Bin) to the already formatted USB stick and then remove it from the PC correctly ...


    - turn off Zgemma h9.2h on the back, using the white power button


    - push the USB stick into the rear USB port of the h9.2h


    -Press and hold the small black RESET button on the back, then


    -Press the white POWER button, holding down the RESET button


    - let go of the RESET button once you see the flashing LED (changing color between white and red)


    -Wait a little'...




    WAIT FOR THE LOADING UNTIL THE USB PEN NO LONGER FLASHES AND THE FLASHING OPERATION IS COMPLETED


    TURN THE DECODER OFF, REMOVE THE USB AND TURN THE DEVICE ON AGAIN, THE BOOT WILL BE CARRIED OUT WITH YOUR NEW IMAGE LOADED !!



    procedura flash x H9.2H


    -Usa la chiavetta USB formattata FAT32-Invia la cartella h9 ed i 2 file (bootargs. bin e fastboot. bin) alla chiavetta USB gia' formattata e poi toglierlo dal PC correttamente...


    -spegnere Zgemma h9.2h sul retro, utilizzando il pulsante di alimentazione bianco


    -spingere la chiavetta USB nella porta USB posteriore del h9.2h


    -Premere e tenere premuto il piccolo pulsante di RESET nero sul retro, quindi


    -Premere il pulsante bianco POWER, tenendo premuto il pulsante RESET


    -lasciar andare il pulsante RESET una volta che si vede il LED lampeggiante (cambiando colore tra bianco e rosso)


    -Aspetta un po'...




    ATTENDENDETE IL CARICAMENTO FINO A CHE LA PENNA USB NON LAMPEGGERA' PIU' E NON SARA' COMPLETATA L'OPERAZIONE DI FLASHING


    SPEGNETE IL DECODER , RIMUOVETE LA USB E RIACCENDETE IL DISPOSITIVO ESEGUIRA' AUTONOMAMENTE IL BOOT CON LA VOSTRA NUOVA IMMAGINE CARICATA!!



    ciao :hello

  • Ciao zorro71!Ho provato tutti consigli ma non parte a lampeggiare resta bianco é bloccato !

    Quando lo bloccato ho mandato tramite totalcomander dal computer per farlo leggere la scheda tivusat con oscam é quando lo riavviato e rimasto in blocco !

Zgemma H9 Support Forum - Combo Tuner DVB-S2X DVB-C/T2 Linux Enigma2 Multi-stream QT Stalker WiFi Digital Receiver

Download Zgemma H9 Twin SE, Zgemma H9 Combo, Zgemma H9 Combo SE, Zgemma H9s and Zgemma H9s SE 4K UHD Series Images and Enigma2 Team Support from OpenATV, OpenBh, OpenDroid, OpenESi, OpenHDF, OpenPLi, OpenLD, OpenSPA, OpenViX, OpenVision, PKT Hyperion, PurE2, SatDreamGR, Sat-Lodge.

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!