Remote channel stream converter problem

on the box slave on setup remote stream converter have u setup ip and port from master box ,and restart the slaver box ??

Hello everyone, my question is: why do I only see channels on the same Tp? Where am I wrong ? How can I show all channels {independently of each other} without putting Stb on standby? Thanks in advance and I hope to receive a little help from you.

Quote from brutus1979

Hello everyone, my question is: why do I only see channels on the same Tp? Where am I wrong ? How can I show all channels {independently of each other} without putting Stb on standby? Thanks in advance and I hope to receive a little help from you.

i presume the other box is a single tuner? its just like recording ie only those on the same TP, or box on standby

Hi pauldb, Master stb has 2 tuners, Slave stb has 1 tuner. So, Master stb {Edition os mio plus 4k}, slave stb {Octagon SF8008 4k}. The settings in master stb are as follows: [Tuner 1] Dvb-s2x, Diseqc 1.1, 8 lnb. [Tuner2] Dvbs2 nothing connected. The settings in slave stb are the same as in master. {Diseqc 1.1, 8 lnb} I managed to connect the remote channel stream converter, I managed to load all the bouquets I was interested in and it works. The problem is that I don't see the channels separately, individually from stb to stb. Example: if I look at a channel [dazn1 bar stb master] I also see [dazn1 bar stb slave], the problem occurs when I change the channel. If I change the channel on stb master I can no longer see dazn1 bar on stb slave. Instead, I see all the channels on that Tp. I hope I expressed myself well. Thank you!

thanks for the reply seagen. does that mean I have to pull another cable from dish to 2 tuner on master stb? if so, I don't think it's possible, I only have one cable, it already makes diseqc on the dvb-s2x tuner. I don't think I can split a single cable into 2 tuners, the frequencies will be divided as well. anyway, thanks again.

Ciao ragazzi, riprendo questa discussione perché ho un problema con il convertitore di flusso sia se scarico i bouquet dal plugin sia dal generatore per pc… premetto che utilizzo vu solo4k openpli 9.0 ma ho provato anche la 7 e la 8. In pratica una volta che ho scaricato i bouquet che vengono trasmessi, se apro il primo canale si vede senza problemi, quando vado a ricambiare canale non ho più visione, se ricambio ancora si rivede… diciamo che fa uno si e uno no.. secondo voi sa cosa dipende?! (Blackhole 3.0.8 non ha questo problema). Grazie.