VisionNet Hammer 5400 rescue-image & telran_1.2.86_app spark sti 7111
Device location link
http://www.telran.co.il/product/1166/hammer-5400
device Hammer 5400 is not a Spark device
Device location link for spark
https://wiki.tuxbox-neutrino.org/wiki/Hardware:Spark
device Hammer 5400 work by Spark system but is not a Spark device
This is the most important differences between the two devices
Spark device that has the internal flash & Ram divided into two parts, each one for the system. One for Spark system
The other is related to the enigma system
RAM: 2x 128MB DDR
Bootloader mit Dual-Boot-Option für Spark (Fulan-Firmware) sowie Enigma2; siehe auch Spark:U-Boot
Notice
It must be distinguished between these two terms
Spark system
Spark devices
Description
S2-St7111 HD is an advanced, interactive digital set-top box based on Linux operation system.
The product support full HD function, enables high definition and standard definition on DVB-S/S2 and supports both MPEG-2 and MPEG4/H.264.
Key Features:
- Linux OS supported
- Fully DVB-S2/DVB-S Compliant
- MPEG4/H.264 , HP@L4.1, XVID, DivX
- Video solution 1080p, 1080i, 720p, 576p, 480p, 576i, 480i
- HDMI HD Video/Audio Output
- Audio Decoding: AC3, LPCM, LC-AAC, AAC, MP3, WAV
- S/PDIF interface (Coaxial) for Doldy bit stream out
- TV SCART/2 stereo audio out and 1 CVBS
- DiSEqc 1.0, 1.1, 1.2 and USALS
- Smart LAN 10/100 Mbps Ethernet
- Software upgrade via LAN Port or USB 2.0
- PVR function support, USB 2.0 high speed, recording and time shift
- Electronic Program Guide (EPG) for on screen channel information
- YouTube, SHOUTcast Radio, KarTina TV and Picasa compatible
- Weather forecast and Rss Reader Functions
- Plug-in installation support
- Support 260mm panel
Code 180431
GUIDE TO FIX RECEIVER ON BOOT
First, remove any external flash that is installed on the device
- use kingston or sandisk usb 4 or 8 GB
- Most of the problems of not accepting the rescue-image will be a defect from the usb that the device cannot read from
- Rescue Soft must be installed while you are on the Spark system, not a system enigma2 Until it is accepted
- It is possible not to accept Soft Rescue from the first times, meaning that you repeat the process once, two and three until it ends and the receiver accepts the software even if it did not succeed. Download another copy of Softrescue until you succeed, God willing,
- In some cases Spark devices not accept soft rescue in by usb So we will use passing the rescue-image for Spark devices using
Cisco TFTP Server
