DM800-SIM2.01-SSL84D_Backup.OpenPli.7.3_piterfree_2020

ok tanke you

hello peterfree i did as you said but it does the same problem

I want to test on an external hard drive

I pass the file normally but when it reaches the boot it hangs.

Quote from marinos

Eu passo o arquivo normalmente, mas quando chega ao boot ele trava.

1 - install the booted sim 2.01 ssl84d and restart

2 - install image openpli 7.3 ssl84d and do not restart

3 - install sim 2.01 ssl84d again and restart

4- configure only in English to avoid boot

thanks canzi

Quote from marinos

thanks canzi

if in your box do not restart with these steps and stay on the display of dream ** stop and the ip.

it may happen have to do for what was mentioned with japharflasher on the computer (recover defective sectors) by rs232 with network by PITER in the previous comments.

if you don't have the rs232 cable and the compatible pc to use japharflasher. don't worry, you can still recover the box via the browser and the ip.

return the firmware pass by the browser

1 - ssl84d nfi

2 - openpli 7.2 or 7.3 nfi other than backup

3 ssl84d.nfi again and restart the dreambox will start the boot

I like this forum and hope i can get my dm800 clone to work

Quote from teak-won-do

Quote from gjn

I like this forum and hope i can get my dm800 clone to work

of course you will get it to work, wy not ;)

pfff no ca found error after installing sim 2.01 ssl84d :(

used serial cable and JapharFlasherv1.1

Quote from teak-won-do

sure you habe DM800 Clone?

dreambox dm800 hd pvr and not the real one i think :)

Quote from teak-won-do

i think so too, look at your SIM CARD make picture and show us

thanks for your help: sim e-star 3.0