Hi I have problem with set correct oscam to start ready NC+ card Cameleon. I was found on internet some news abaut i have to set oscam on 1813. Did anyone have that oscam set and cen give me a link . Thanks
HI i have Zgemma H7S need OSCAM NC+
- rsobczynski
- Thread is marked as Resolved.
There are 8 replies in this Thread which was already clicked 1,465 times. The last Post () by rsobczynski.
-
-
master G
Approved the thread. -
Hi, I have zgemma h7 work fine oscam patched 1813
please check this work but you need
nuid =
cwekey0
-
Thank you but where I have to copy that files??.
-
Hi, I have zgemma h7 work fine oscam patched 1813
please check this work but you need
nuid =
cwekey0
how to use patch
-
I would like to know as well
-
Thank you but where I have to copy that files??.
Steps to install:
Copy the Oscam Binary to the STB directory / usr / bin / and give the permission 755 or 777.
Copy or create the Oscam configuration files (oscam.conf, oscam.dvbapi, oscam.server, oscam.srvid, oscam.user) into the STB directory / etc / tuxbox / config / oscam /. Authorization 644 is sufficient for the configs.
In the STB directory /etc/init.d/ create a script file named softcam.oscam ......with the following content:
If you want, you can enter the current version number of your Oscam Binary instead in the script, but you do not have to.
The file softcam.oscam must have the authorization 755 or 777.
Now test it in a Telnet console via /etc/init.d/softcam.oscam start if Oscam starts. If there is the error message “/ usr / bin / oscam: error while loading shared libraries: libusb-1.0.so.0: cannot open shared” then you have to install libusb.
-
sorry i was try do this and is not working. did you have in one folder all files whit I have to load in??? I have oscam 11578
-
100 % working .
Did you put ?
nuid =
cwekey0
-
No sorry I done all but form wher I have to take datum for NUID and cwekey0 ??
And did you add please oscam config files please as well.
I copy your files to etc/bin and change name to oscam.stable
OSCam Support Forum
Configs, discussion, downloads and guides for OSCam Softcam.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!