Hello,
How can I flash Openvision on ET10000 from USB ? There is zip file and STB cannot read it. Necessary uinzip ? How ?
Thanks
Openvision flash on ET10000
-
- Image Flashing Support
- Xtrend Open Vision
- bralen
- Thread is marked as Resolved.
-
Extract the zip file with winrar or 7-zip.
Inside the zip file is an et10000 folder with the required image files.
Copy the et10000 folder to a usb stick then try flashing again.
-
But I have this in et10000 folder, see zip file.
That`s correct.
Copy the zip file to the usb stick > right click the zip file then select "extract here" > you will now have an et10000 folder with the image files inside.
-
This is OK ?
NO!, why are you copying the files to the internal flash memory?
To flash a new image the files much be on the usb stick.
Copy the et10000 folder on to a formatted usb stick > Do not remove any files from inside the et10000 folder. Leave the et10000 folder intact, with the files inside it
-
Do not try to extract the rootfs.tar file or modify any other files inside the et10000.
Its simple, just copy the et10000 folder to a usb, then try to flash the image
-
I did it like you wrote. STB freezed, on display BOOTING only
Start again with a different image first to get the box booting, then try open vision again.
-
-
Try to change the name NOFORCE to FORCE
Firmware, downloads and support for Xtrend.
Your community resource for the Xtrend satellite receiver — firmware images, channel lists, plugins and setup help.
