Hi all, had anybody seen something like this?
As you can see, ecm times start ok but each client connect respectively with a higher ecm, first one gets a good time but last one a bad time. The connections seem to be sorted.
Hi all, had anybody seen something like this?
As you can see, ecm times start ok but each client connect respectively with a higher ecm, first one gets a good time but last one a bad time. The connections seem to be sorted.
I tested also with preferlocalcards = 2 with same result.
I tested also with preferlocalcards = 2 with same result.
Could it be something to do with [cache]? Clients could be receiving bad cache.
I don't know, maybe. But I don't understand why clients get a higher ecm in order of arrival or connection. I had never seen something similar.
A correct log would be :
[1810:000000:6FF0] [803086078400E5786D10...] ok (268ms) | VH
This log is got with same card but reading with sbox.
You could try reducing the lb_weight by 50 to 250, 200, 150 etc to see if it improves the response time.
Has it always been stable until now?
Is the cardmhz ok? Which receiver is reading the card?
You could try reducing the lb_weight by 50 to 250, 200, 150 etc to see if it improves the response time.
Has it always been stable until now?
Is the cardmhz ok? Which receiver is reading the card?
Not, I was using sbox before install oscam and all times were ok, but sbox can't be used with new OE-Alliance Cores (higher than 4.1).
The cardmhz is ok, the same used in sbox. The receiver is a vuplus solo2 but also tested in Edision OS Mega, Formuler F4 and Qviart Lunix3.
I will try your recommendations and come back with the feedback.
The cardmhz is ok, the same used in sbox. The receiver is a vuplus solo2 but also tested in Edision OS Mega, Formuler F4 and Qviart Lunix3.
Models with MIPS-CPU use "cardmhz = 2700"
If only the parameter cardmhz is set (without mhz = xxx) then Oscam clocks the card automatically with the ATR!
I also tried with
mhz = 2700
cardmhz = 368
.
and same result.
Maybe the correct is
mhz = 368
cardmhz = 2700
??
Maybe the correct is
Yes that`s the correct way to set it.
You can also remove mhz value and let oscam set the correct frequency itself.
Don’t have an account yet? Register yourself now and be a part of our community!