Which image did you try to flash on it?
Use JapharFlasher to repair bad sectors, flash the correct bootloader and compatible image for the ferrari sim card.
Image for dremabox 800 hdse ferrari ssl84f
if you flash please set "recover bad sectors" too, good luck
try this image in Attachment, after you can change image your choice
Recover Bad Sectors (HowTo) : DreamUp/JapharFlasher & Telnet
You have the example below of :
- DreamUp/FerrariFlasher/JapharFlasher, to set the RBS.
- 3 Telnet screenshots to show how to set RBS (that is available in NFI image upload mode).
where the problem??
Don`t flash via the browser use the JapharFlasher.
You currently have bootloader SSL84D so use this image ~ openpli-7.2-dm800se-sim-ferrari-ssl84f-20200129
If you prefer a different image flash the SSL87F bootloader then one of the other images that were linked.
Make sure the images used match the bootloader or you will get another error.
Flash with ..... what?
Do you not see JapharFlasher by Goodsat linked in post #2?
Flash with ..... what?
Do you not see JapharFlasher by Goodsat linked in post #2?
a person told me that we must reinstall all the boot from the beginningI tried but nothing
What steps did you try?
Repair bad sectors?
Flash the bootloader?
Flash a compatible image? Which one?
We are trying to help but you need to help us with as much info as possible buddy.
Repair bad sectors with JapharFlasher
boot loader exist is 84
flash with openpli-7.2-dm800se-sim-ferrari-ssl84f-20200129
it make me successuful
after the box remain on adress ip
Please try with this tool ~ Dreambox OptiFlasher Enigma2 EDition Latest Version
Display MoreRepair bad sectors with JapharFlasher
boot loader exist is 84
flash with openpli-7.2-dm800se-sim-ferrari-ssl84f-20200129
it make me successuful
after the box remain on adress ip
you must flash with cable ,not enable ftp !and you must use Japhar loader ,on time about 12 minute !
wht ? you have micro cable for conect ?
CodeI couldn't do anything
please read here too klick me
wht ? you have micro cable for conect ?
Go with telnet to the box IP, and then on the Box BIOS Menu select the reset settingd to factory default.
Emo
Don’t have an account yet? Register yourself now and be a part of our community!
