Oscam power vu chanels and neosat

There are 6 replies in this Thread which was already clicked 2,022 times. The last Post () by Amiko73.

    Hi all!

    I'm trying to make it work onoscam emu the power vu channels(0,8 w & 4,8 e) and Neosat(1,9 e) without any result. Can someoane help me?I use openav 6.4.

    Many thanks in advance.

    Edited once, last by Amiko73 ().

  • master G

    Approved the thread.

    i'm trying too :(


    This is for openatv ! Make sure you have a recent oscam emu easier to use recent oscam.ipk to set it up . Load very recent SoftCam.Key file to config folder etc / tuxbox / config (usually) or etc / tuxbox / config / oscam-emu . Should work! All info files to be found on this web site

    Quote from Amiko73

    Hi all!

    I'm trying to make it work onoscam emu the power vu channels(0,8 w & 4,8 e) and Neosat(1,9 e) without any result. Can someoane help me?I use openav 6.4.

    Many thanks in advance.

    look in Oscam-Emu


    and it will certainly depend on your box the box you have not mentioned




    PowerVU config files for oscam-emu


    OSCam Emu Config Mario for all PV providers


    Oscam-emu Configs


    dont open 1.9 degree neosat package

    parabéns cr7 & moliveira88

    Μπρέντφορντ Φ.Σ

    RIP Vangelis Papathanassiou

    Edited once, last by Antepenultim8 ().

    Like 1

Your resource for OSCam softcam

Find configs, downloads, tutorials, and support for setting up and optimizing this open-source card server with wide protocol compatibility. Master the versatile OSCam softcam. Access support, configs, tutorials, and downloads for open-source card sharing and multi-protocol server management.

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!

Register Yourself Login