HD800 with a motor using Diseqc 1.2

There is 1 reply in this Thread which was already clicked 1,224 times. The last Post () by master G.

    I have a HD800 with a motor using Diseqc 1.2


    HD800 doesn't seem to save the satellites added


    Am I missing something? This is what I'm doing


    1.Open motor settings and select satellite Astra 1n/2a/2b
    2.Motor type Diseqc 1.2
    3.Limit setup is set to disable limits
    4.Save my motor settings for Astra
    5.Open satellite list and I run a scan for Astra 1n/2a/2b
    6.Save all channels found
    7.Open a channels to verify I can watch it
    8.Go back to motor settings and select satellite Hotbird and I move my dish with the motor to hotbird
    9.Save my motor settings for Hotbird and I run the scan again from satellite list
    10.Save all my hotbird channels
    11 Select a channel from Astra


    I get not signal


    My Astra satellite doesn't get save when I add hotbird. Hotbird overwrites Astra


    Is there anything I'm not doing wrong?


    My Technomate box works like I have done with the motor without any prolem


    Any help much appreciated

    • Official Post

    Maybe this will help,

    [h=3]Setting up a DM800 none usals[/h]
    Also update your sat.xml file or load a latest channel list.


    I used to own an older DM800 clone & found a reboot was required after saving every sat for it to store properly when setting manually, maybe usuals is a better option for you.


    [h=3]Guide for setting up usals for DM800[/h]
    Hope this helps.

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!

Register Yourself Login