my dm920 not working
open start then stop
how can i fix
have IP addresses can't get to it with any than Dcc
any one can help ..
Thanks to all
my dm920 not working
open start then stop
how can i fix
have IP addresses can't get to it with any than Dcc
any one can help ..
Thanks to all
Do you have an FBC tuner, if so, open the box and try to press the tuner, maybe it's loose
if not it sure is one definitely a hardware defect. send box back to seller
it is Original DM920 think it is software problem
wish some one knows how to fix ..
sorry but this is no software problem, is hardware problem
my dm920 not working
open start then stop
how can i fix
have IP addresses can't get to it with any than Dcc
any one can help ..Thanks to all
Try WinSCP tool (SSH/FTP) as well as Putty that works much better, as DCC is buggy,
Emo
Fcc is working and can go inside but what to do ??
I had the same problem with my dm 920.
Just flash new image with dream up tool.
I do that with openatv 6.3
it is working now change enegma from the original image now 100% OK
with Fcc i change enigma2 as i read with setting ..
thanks A lot to All
I had the same problem with my dm 920.
Just flash new image with dream up tool.
I do that with openatv 6.3
How did you do that?
i have the same problem
try this image is the End open Atv
1
first, open common interface
you just need a tick slot 1 - 0x500
it also does in slot 2 - 0x500
remember to restart afterwards when you are done with the common interface
2
preferred tuner should be on auto
preferred tuner for recording should be off
remember to restart afterwards when you are done with preferred tuner
I hope you use my guide on how to use OpenTSimage 9.x for recording and watch other TV programs in the meantime
if you for help
then write in
Don’t have an account yet? Register yourself now and be a part of our community!