Need CCcam 2.3.0 for original Dreambox DM800HD

Hello.

Gentlemen, for two months I have been struggling to run cccam 2,3,0 in img, different. Unfortunately, I couldn't. As it is in ipk, it shows that it has loaded and if I am looking for it, it is not saved. As I put into individual folders, the green screen shows me. If any of the gentlemen has IMG bacukup with active cccam 2,3,0 to DM 800HD PVR Original. I am asking for sharing. I would be very grateful for your help.

Hello.

Thank you mate teak-won-do. Unfortunately, as I wrote img. BlackHole-4.4-DM800-SSl84-20180326.rar has no cccam 2.3.0 and the given scm-cam-cccam_2.3.0-r0_mips32el.rar gives 0 record when saving, so it cannot save it in ipk. For this, I would like to ask if someone can write in img. I do bacukup of the entire img. And share me so I can save the whole img then I hope it will work. I also thank the admin for the hint, but I only have cccam 2.3.0 stably. Maybe someone will help a friend. I care a lot. Please.

This time it displayed that it unpacked, but after the gui reset, the cccam is missing. Strange because this cccam 2.3.9 that I downloaded from the page that Admin provided uploaded and works, but it breaks the image as described there. Stable, I only use cccam 2.3.0.

As I wrote above, when installing ipk. Some sees 1 and writes installed, others does not see 0, but does not install any. They are gone after the gui reset. Only properly installed cccam2.3.9 weird. And this is cccam2.3.8. also did not install. I don't know what to think anymore.

Approx. So I will. I will delete IMG and load it again, then I will start installing from cccam 2.3.0 and more. If necessary, I will delete IMG every time and I will upload it again. For now, thank you very much and I'm getting to work. I will call you tomorrow, I will describe what came out of it. Greetings.

Hello.

I did everything all over again. I installed img. BleckHole I tried to upload cccam 2.3.0. Unfortunately, it didn't work, so I uploaded cccam 2.3.8 and it worked, but after each cccam reset, green screen and gui reset. I also tried to upload what my colleague teak-won-do gave, i.e. img. Newnigma2 ipk everything seems to be ok, but when starting the green screen and so on. Maybe this ready img. with this cccam 2.3.0? Help, colleagues.

Hello.

Thank you mate teak-won-do, that's what I mean. Successfully uploaded and everything works. I also thank the admin for any comments. After two months of researching, I can finally watch as normal. Thank you again for your professional help and patience. Best wishes.