I have installed PurE2-6.3 on the dreambox 900 but get no contact with the receiver
login: root
password: pure2
I have installed PurE2-6.3 on the dreambox 900 but get no contact with the receiver
login: root
password: pure2
Hi.
Check the LAN configuration in the Enigma2-GUI (SKIN) - using the RCU.
What do you see there ? Do you have IP, MASK and DNS assigned ?
Hi.
Check the LAN configuration in the Enigma2-GUI (SKIN) - using the RCU.
What do you see there ? Do you have IP, MASK and DNS assigned ?
everything is ok i get connect with openwebif
But not on FTP tested 2-3 FTP PRORram it's the same on all
Could it be because I have installed with BA
There are 6 installed image with BA them works itan problems get connect with all
I don't know. But some PurE2 expert should answer here :). I don't remember his exact nick-name, but he's also here on this discussion forum (PurE2 development team).
Does the Telnet connection work ? Did you set a password via Telnet ? For most Enigma2 distributions, it is necessary to connect first via the Telnet protocol (terminal connection using the PuTTY application, for example) and change the password there with the command:
passwd
Or try to check if the FTP / Telnet / SSH services are running at all. However, these services do not have to be enabled and started on every Enigma2 distribution by default. For higher security reasons, they can be stopped by default. They should also be able to be enabled (started) using the RCU, in the Enigma2 GUI.
changed password it is the same no connect ftp
Is the FTP service (server / daemon) running ? It should be possible to verify this in the Enigma2 GUI, it will normally find it somewhere in the MENU... probably under the "network" or "network connections" setting.
it looks like everything is ok but no connect with ftp
Do you also use a VPN network ? If so, try temporarily shutting down.
The configuration of the WiFi router (LAN switch in your network) is OK ? Try disconnecting the LAN cable between the set-top box and the WiFi router. Then switch off the set-top box and the WiFi router (completely disconnected from the mains). Then turn on the first WiFi router again and wait for it to boot for a few minutes. Then reconnect the LAN cable between the WiFi router and the set-top box and turn on the set-top box. Test if FTP connection is already working.
If the netstat command works in PurE2 image, try this in Linux Shell:
netstat -tulpn | grep LISTEN | grep 21
Sadly we do not have dm9x0, so we have put it in sort of unsupported state. We had conflicting reports with v65 versions (work yes/no). Until we get the box, no sense to punish users or ourselves.
Just for information - Dream Two works.
Sadly we do not have dm9x0, so we have put it in sort of unsupported state. We had conflicting reports with v65 versions (work yes/no). Until we get the box, no sense to punish users or ourselves.
OK but what's wrong there ? With what ? NIC driver is faulty ? Or some system libraries ? Or what's wrong there ? Or FTP daemon itself is bugged ?
Where did you download the Image from maho33 ???
Can you post a link and I will checkit out.
There where som issues with other images based on OE-A where only ftp works over ssl
This was an error in many images for Vu+
Display More
thanks this one works without any problems
Don’t have an account yet? Register yourself now and be a part of our community!