help - Can the conax card be shared

Hi.

I think yes.

But it also depends on the specific provider and their decoding satellite cards. They may contain some algorithms to protect sharing. I'm not an expert, so I don't know exactly.

However, I know for sure that, for example, the ANTIKSAT provider with CAID=0B00 and CONAX encoding can be shared.

However, I also know that some CONAX cards require pairing with a hardware access device. They don't answer otherwise. So you need some key for Oscam in that case.

This may vary from case to case. So it's hard to advise you. Even a specific sat provider can after some time start producing newer decoding cards that have some protection included in them (SurfLock protection is known for example).

It's hard to say what's wrong. There can be many reasons.

Try writing http:// before the IP address. Try verifying the port again in the oscam.conf configuration file. Restart Oscam every time you change its configuration. Check the connection to Enigma2, also by trying to connect to FTP or SSH / Telnet services (if these services are active in your Enigma2).

I don't know what exactly you want from me.

After all, you wrote that you already have Oscam installed and functional. And that the problem is that you cannot connect to Oscam-Webif.

But now you are asking for the overall process of installing Oscam.

I don't know all the set-top boxes in the world and unfortunately I don't know all the Enigma2 distributions either.

First of all, it depends on which Enigma2 distribution you have installed in the set-top box (developer team name and also version number).

Secondly, I don't know if you used some kind of installation package or just a binary file. In the case of a binary file, the question is whether you followed it correctly (there is a slightly more complicated procedure).

In the end, the problem may not be in Oscam functionality at all, but in you... maybe you configured Oscam incorrectly or there are several configuration files contained in your set-top box and they are crossed (after starting, Oscam looks for configuration files in several folders, but uses the first one found).