Usals motor issue moving from horizontal to vertical frequencies

There are 2 replies in this Thread which was already clicked 759 times. The last Post () by jojoz.

    Hello! I have a problem when I am trying to switch from horizontal to vertical transponder on another satellite with stab usals motor. The dish won't go to the specific satellite but keeps moving. However, this is not happening when switching from horizontal to horizontal transponders between satellites. BTW I have an Octagon SF8008 enigma2 receiver and a quad lnb. Is anyone experiencing the same problem? Is there any solution?

    Thanks in advance

    Hi friend, I also have an octagon8008, and a multi-head dish + motorized dish, but I have never encountered this problem.....try with another head (lnb) if you can to see the result.....

    Thank you for your answer my friend. I changed the lnb with two different quads that i have , but still the same problem with both. I dont't know if it's related to quad's lnb higher current consumption compared to single's or twin's.

Master your satellite setup with expert installation support.

Get dish alignment help, LNB guidance, and configuration tips for single, multi, and motorized systems. Your technical forum for satellite installation. Get support for LNBs, DiSEqC switches, motorized systems, actuators, and dish alignment for any setup.

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!

Register Yourself Login