Hello i had a problem in remote control vu+solo original is not work anymore after work with my new one universel sd2with red bouton tv but the universel work fine after put code but the original when i put stack of remote in the screen of receiver it like a green light dont stop like i clik on button how i can comeback to work with my original thanks
problem remote control vu+solo
- RHINO94
- Thread is marked as Resolved.
-
-
oktus
Approved the thread. -
maybe you put it onto tv mode, try pressing and holding stb button then ok button
-
no it doesnt work this metod with original remote but the fake still work fine
-
Factory setting/reset:
Would you like to return the remote control to its delivery state?
Hold down the two number buttons "1" and "6" for 3-4 seconds until the control LED lights up.
As soon as you have entered the code sequence "9" "9" "6" using the number buttons, the remote control will be reset to the factory settings.
Now you can make the desired settings again.
################################################################################################################
Code setting - receiver:
Adapt the remote control to your existing Vu+ receiver.
To do this, proceed as follows:
Hold down the two number buttons "2" and "7" for approx. 3-4 seconds until the LED lights up to check.
Now press the “HELP” button. Depending on the receiver model, you can now enter the four-digit code number.
Once completed, you can test the remote control on your receiver.
Code number Vu+ Duo + Solo: 0001
Code number Vu+ Uno + Duo 2 + Solo 2+ Solo SE: 0002 -
ok ihave this instruction but the original dont have the button led red
-
ok next try
1. Press buttons 2 and 7 simultaneously for about three seconds until the LED at the top left lights up
2. Press the HELP button
3. Press <0001 or 0002 or 0003 or 0004> depending on the VU+ model you are using
4. Exit the programming with the EXIT button
-
LED at the top left lights up
-
ok the other original is bouton mute how to comeback towork with original no response on receiver
-
is i need plugin code remote control that you can send it to me in what image i have to install it
-
the problem is the led inside dont turn off when i saw with camera
-
master G
Moved the thread from forum Enigma2 Tools to forum VU+ SOLO. -
I think your remote control is type 1 and this type is not programmable
maybe the batteries are empty, or there is a technical defect
Unfortunately I don't have any other solutions
-
this is the original that i had but the light still on when i put the batterie
-
i changed the batterie of remote today the white light still on
-
Here is the pdf for your box.
http://vuplus.com/manual/SOLO%20User%20Manual_English.pdf
How to use the remote instructions are in the last few pages of that pdf.
But if I were you, I would just buy another one off amazon for £10. Saves all the messing about.
Or give every button a wiggle and see if you have got a stuck button.
-
i have one remote standard but i want to comeback to original
-
the problem is the led inside dont turn off when i saw with camera
if you mean the infrared led (because you refer "through" the camera) , than this isn't programming problem, but on of the buttons looks stuck, and blocks the rc
-
eventually not repared problem in circuit
-
i went to recovery
VU+ SOLO PVR Ready Linux Enigma2 Receiver Full HD 1080p
Download VUPlus Images and Enigma2 Team Support from Black Hole, OpenATV, OpenBH, Open Black Hole, OpenDroid, OpenESi, OpenHDF, OpenLD, OpenPLi, OpenSPA, OpenViX, Open Vision, PKT Hyperion, PurE2, SatDreamGR, VTi.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!