Zgemma h9 s se
- darius50
- Thread is marked as Resolved.
-
-
If the installation of the "recovery" image does not work !
You are lost !!!
- put the recovery image on a FAT32 stick (unarchived)
- press recovery switch on the back panel
- power-on Zgemma keeping pressed the switch
- release the switch after logo appear and ... wait !
-
Linux1 appears. I'm trying to install the system. Nothing helps. you have to wait a long time for the subsystem. After installing recovery. later software . there is no software after installation. botables text only.
I can't connect to the Internet via cable. lost driver systems
-
Try to install OpenATV 7.4 recovery image ! that one contains the last full image !
When recovery install ends ... must boot the normal image ! If this does not
happen ... is a bad sign !
-
neither ATV recovery nor ATV system. After installation, no system.. only botables text only .as if there was no subsystem .muliboot you have to wait a very long time, about 2 minutes
-
Probably EMMC Flash ... is gone ! this is the bad sign ...
-
how to repair EMMC flash .
Zgemma h9s SE
-
how to repair EMMC flash .
Zgemma h9s SE
Turn off the receiver from the power supply.
Press POWER on the remote control and while holding it, turn on the power to the receiver.
Bootmenu appears?
-
-
-
- download https://images.mynonpublic.com…0240209_recovery_emmc.zip
- copy without unpacking to USB
- turn off the receiver from the power supply
- insert the USB into the receiver
- press POWER and turn on the receiver
- enter Bootmenu <-> Flash Local Image <-> select Image <-> select slot
-
OSCam Support Forum
Configs, discussion, downloads and guides for OSCam Softcam.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!