Problem Oscam l2b and mipsel box

[reader]
label                         = SLOT0
enable                        = 1
protocol                      = internal
device                        = /dev/sci0
pincode                       = 0000
caid                          = 0624
force_irdeto                  = 1
#needsemmfirst                 = 1
detect                        = cd
cardmhz                       = 600
group                         = 1
blockemm-unknown              = 1
saveemm-unknown               = 0
disablecrccws                 = 1

Do not forget to allow AU

and it doesn't work for you

remove this ccchop = 2 cooldown = 30,600 form your config and try.

He already wrote that in #2.

Seriously do you need an EMM to cache ?

My card has been working without EMM cache since November 28, 2010.
capture_001_30012025_230624.png

Quote from machura

cooldown = 30,600

Why? cooldown = 30,600?

A stále nefunguje?

translate: And it still doesn't work?

[reader]

label = Skylink_(L2B)

description = 11523

protocol = internal

device = /dev/sci0

caid = 0624

boxkey = 16BEDD5E2A2C17AF

rsakey = 1B4368AD00D5AE23977576FCB202D84897994B358F006B42CB4BCC2301D1FAE2BCF4C397ED4DC7DE6DCE4A1A3D88682DB672827831FA8E6B6E29E7AD37D0A21F

force_irdeto = 1

needsemmfirst = 1

detect = cd

mhz = 450

cardmhz = 2700

group = 1

emmcache = 0,2,15,0

any oscam coder in here?

Quote from machura

On Osnino Pro (mipsel box, enigma2ú, I use the standard OSCam for a local reader with an ICE card switched to Irdeto, no share. Since some newer channels can't be decoded in a unicam reader with the standard OSCam, I'm trying OSCam L2B (Samur). Unfortunately, after about 30 minutes, the picture stops working, even though the log still shows it as decoding (in lower in example)—this happens even on channels that don't require the L2B version. Must be restarted or rebooted box. If I replace the binary with the standard OSCam, everything works fine. I asked in the modification author's thread, but the only response I got was to start my own thread, not use his OSCam version, and then the thread was locked. In my next box (arm box) works samur verison well.

example from log (removed info about service), when :

(ecm) dvbapiau (0624@000000/0000/...): found (102 ms) by cardL2b (L/1/7/7) - ... HD (lg)

which one is your card there is ICE card old one and pure Irdeto card. I got access to also one and no channels is working but i am using different box/rsa than above

For ChID 0000 at 0624, a correct BOX/RSA is required

For ChID A000 at 0624, a correct oscam with L2B support is required