Hello to all
This training is offered for the first time, The training I did and realized experimentally.
With this training you will be able to synchronize the images to use OE 1.6 and OE 2.0 simultaneously.:red:
Flash image you must necessarily be OE 2.0, OE 2.0 images that you use the flash device, must be Intramfs patch, so if the image or Newnigma2 like CVS or any other image you use, you must patch your Intramfs Flash image device installed, you're not familiar with the installation of this patch in the image, the image is proposed to use ozone as a basic image, because image Oozoon, Intramfs patch is installed by default.
Well, the flash device to prepare the image, turn it to LOW FAT plugin.
LOW FAT 5.2 plug should be used for this work.
So a LOW FAT image using OE 1.6 multi boot.
Important point:
LOW FAT from the image in any way that you have multi-boot, do not boot to the flash device, otherwise it is broken down into each image.
The image should boot flash device, turn off the image, then a bit too flash, then turn on the receiver to the flash image to boot.
If you want to make synchronous OE 2.0 multi boot images, you must have a flash time.
Next point:
If your flash image is OE 1.6, OE 2.0 can not multi-boot image, flash image, you must be OE 2.0, then you can multi-boot image OE 1.6.
I hope you enjoy this tutorial.:69:
by Eminem
