Thanx to the author/s of this kit
Instrucstions
1.Connect your RS232 LEAD to the ***BOX F3 then go to device manager check which port your rs232 is on (port 1 is default)
Go to windows device manger to check
2.Now select corresponding port on the erom software.
3.Press upgrade & select the ***box f3.abs enclosed in the erom folder.
4.Switch off the ***BOX F3 at the rear of the box.
5.Now press "NEXT" then turn the box on at the back you will now see "Com Port OK"
6.The loader will now start loading slowly. (allow the firmware time to load even if it hangs at the end wait for completion)
If it fails to start loading,turn the box off via the rear power switch & again press "NEXT" then turn the reciever back on,it may take several times before the box starts to load the firmware.
Ive tried this method and it does work
