Need idiots guide on how to put my C lines on my Alien2

Hi All

This is my for post and i hope to Help.

This reply is for Non programmers, on how to connect C Lines and N Lines on Alien 2.

Firstly, and to make this really easy on your self, You need to download and Install,

1. Oscam4Spark Tools Plugin,

and make sure you also have
1. pligin_camconfig.s
2. mgcamd xh4 plugin
3. am214 plugin.

assuming the above is installed you are now ready to
program your C Line or N line.

C Line setup

Start the Oscam4spark tool and add or edit your server Cline details
save and exit back to plugin list.

Start the Plugin_camconfig and enter to oscam .
you will see the server details you edited in the tools plugin.
exit oscam and details will save again.

for c Line you have to options at the point.

option 1
Select MgCfg
select cccamd
edit you server details

if you use the above option
you will have to start the mgcamd sh4 Plugin and turn off the oscam4forsparl tool plugin

option 2
select CcamCfg
enter server details details

if you use the above option
you will have to start the CCam214 plugin and turn off mgcamdsh4 and oscam4sparktools plugin.

For N Line

Use option 1 only

This time tho when you edit your server in the oscam4spark tools,
make sure
1. your protocol is newcamd
2. the des key is 01020304....14

option 1
Select MgCfg
select newcamd
edit you server details
exit back to plugin screen

disable oscam4sparktool plugin
enable mgcandsh4 plugin

For both Line types
after completing setting
reboot your box

and you should be connected with either line type.

E&O Expected.

Good luck

Tony,
Do you know how to do it on Enigma rather than Spark?
Thanks
Shaun