1 IMPORTANT
a Microsoft DotNet Framework 4.0 is required.*
b. Partitioned and formatted USB flash drive is required.*
c. The configuration of multiboot is possible, but only from E2/Neutrino. It does not work out of Spark.*
d Mulitboot Since version 0.8 also works with USB-connected hard drive port.*
2 configuration:
a start program.*
b. Press on the "configuration" (Configuration).*
c. Select "Amiko Alien." (For all Spark 7111-boxes) or "Spark 7162" in the drop down list*
d Set the IP address.*
e Set password.*
f Save Settings*
g End Program
3 Image instalation:*
a."Extract Image partition on" (Extract image on partition) Select.*
b. Select the USB drive from the drop-down list.*
c. The partition table should be filled in automatically if the partitioning* Check the USB flash drive (see 1.b)*
d set for the partition to be used, as follows:* i - the name (label)* ii. - Than EXT2 file system*
e Verify that the option "Format the partition always unpack before the image"* (Always format partition before extracting image) is activated.*
f "Image Extract" (Extract image) select.
4. Mulitboot Configuration:
a "multi-boot manage" select (manage multiboot)*
b. "Read" (Read) Select.*
c. If the program detects that runs a Spark Image, the configuration* Options are disabled.*
d To add a new position to multiboot set, the name in a field near* the partition number and press "add" (add).*
e In order to activate the image of a given partition, "Enable Image" (Activate image)* and then select start the box again.*
f If the image does not boot from USB, it could not be properly extracted.
