New STB VU Solo

Managed to get 2.1.4 to load, other gave errors, some loaded but never showed up.

Downloaded a picon package and added it to the usb hard drive, gone into epg and presses menu and altered the setting to 5 per page but the picons still arn't showing?? is there a settings that needs turning on or to set the destination of the folder where I have saved picons??

Cheers

Tried that

Quote from master G

Have you mounted the usb drive ?
Menu, Setup, Vix, Devices Manager, red button for Mountpoints.
Then make sure the path is /media/usb

Where I'm supposed to press red there is noting listed at the bottom of the screen but when I press red I et green screen.

Its let me do it this time and the box is rebooting

Sorted cheers

How do you view ecm info on the box, when I press OK or view ccaminfo on the stb the time shows as ncn.

Ok mate, time to look for a new link couldn't get along with the ones I found before.

Keep getting errors when trying to install (tried a few) main errors are some of the files its trying to create are already there.

Nope no luck don't seem to want to go on at the same time, how do remove 2.1.4 completly, and then I'll try a few 2.2.1's

Quote from master G

Menu, Plugins, "Red button" Remove Plugins, Cams, highlight the cam you want to remove then press Ok.

In softcam manager there was only 2.1.4 displayed, so as you suggested I went into plugins and removed 2.0.11, 2.1.4 and 2.2.1, then added 2.1.2 into temp and all installed nice. So I have 2.1.2 running with all ecm info.

Thanks again Master G.