Hi,
I've put masterG VIX3.0 image on to my new Maxdigital XP1000. I've inserted my nline into the newcamd.list in /usr/keys
CWS_KEEPALIVE = 300
CWS_INCOMING_PORT = 21000
CWS = xxxxxx.xxxxxx.xxx 32000 snapplejacks password 01 02 03 04 05 06 07 08 09 10 11 12 13 14
MG_CFG also editted, changed the box type to dreambox/mips
# box type
# 00 autodetect, change only if you think wrong type detected.
# 01 dbox2
# 02 dreambox
# 03 triple-dragon
# 04 relook
# 05 openbox
# 06 dreambox/mips
# 08 stapi/kathrein
# 09 stapi/ipbox
# 11 stapi/openbox
B: { 06 }
still no success after the above, i've checked my mgcamd_138 is active on Softcam Manager. I have to be getting close !?!?!? any further suggestions ?
also, i should add, i've seen stuff out there about an ipk file for mgcamd, but i'm not sure what or where i get it....on my image there may be a requirement to install local extension for this ?