1) Press the Menu button
2) Scroll down to Network Local Setting
3) Scroll across to CCcam plug setting
4) Click Manage Config Files
In manage Config files:
1) Select CCcam.cfg
2) Click on Add (Blue Button)
This is how to enter your information in the correct order:
Leave the protocol as CCcam
Host = IP Address or dyndns address
Port = Port Number
User = Username
Password = Password
So for exampe if your information looked like this:
C: 192.168.1.6 12000 example password
Then in Host you would enter: 192.168.1.6
In Port you would enter: 12000
For User you would enter: example
For Password you would enter: password
Once all the above steps are complete press the yellow button
You should now see the cline: C: 192.168.1.6 example 12000 Offline
Press the Green button and it will add a tick next to Offline
Exit the menu and it will tell you it's saving
Give the receiver a complete restart and providing you are connected on your local network/internet the receiver should connect to the server using the details you just entered.
If you are going to use a USB stick to send over the the Cccam.cfg file rather than entering it manually as detailed above then the best way is to make a notepad file and enter on the top line:
C: 192.168.1.6 12000 example password
Save the file as CCcam.cfg file and load it in using the options in the menu. Once loaded on again make sure the info is marked as active then give the receiver a restart. Again providing your network settings are good the receiver should now connect to the server using the details you've entered.
