dm800se openpli 3.0 hdd wont initialize

**kemestri** · Jun 14th 2013

I have just changed the image on my dm800se to openpli 3.0 (specifically so I could use the on-demand plug in)

on-demand working great but cannot get my hdd to initialize.
when I try to record or set up cross epg, it says no hdd or not initialized.

however when I try to mount/initialize from the tspanel it appears ok.

the hdd was working fine with my old image yesterday

any advice please

**master G** · Jun 14th 2013

This guide is worth a try here --> http://linuxsat-support.com/vu…r-telnet-commands-vu.html..

kerrs69 · Jun 14th 2013

hiya mate I had the same problem last night , when I installed tspanel and tried downloading something box stopped working , had to reboot and lost my usb and harddrive , had to flash the 800se firmware from here

Downloadcenter | dream-multimedia-tv.de

flash that and 84ssl then follow setup and will ask you about hard drive and usb if connected !! then after that's all done just start again with openpli

dm800se openpli 3.0 hdd wont initialize

Firmware, downloads and support for Dreambox DM800SE - DM800SEv2.

Share

Tags

LinuxSat Community

Firmware Images

Receiver Support

Plugins & Tools

Resources