Hello,
I have a problem that is driving me crazy.
I have at home a decoder vu + only 2 where I tried to install any version of any image with cccam.
Now I have mounted an image vti
I write the cline in CCcam.cfg file
Every 30 minutes exactly have a still image of 3 or 4 seconds and then starts again for another 30 minutes exactly, TIMED!
As if there was a timer.
No one has ever had this problem?
It is not that there is some control that takes place every 30 minutes that I can disable?
I have not found anything in the various menus.
Thanks in advance aid.
Block every 30 minutes
- ricsantu
- Thread is marked as Resolved.
-
-
Hi ricsantu, an intro post is required before you use the forum buddy, here --> Introductions.
Enable these two lines in CCcam.cfg then look at the log in /var/log/messages.txt & warnings.txt
-
Ok done.
I await the block -
I had another block.
I did not find the file warnings.txt
On var / log there is the messages file
I tried to open it but do not understand anything.
How should I do? I can post? -
I had another block.
I did not find the file warnings.txt
On var / log there is the messages file
I tried to open it but do not understand anything.
How should I do? I can post?Post or attach the log file..
-
I attach file
-
You can not understand something?
-
You can not understand something?
There is nothing in the log that helps us find a solution..
The problem may be with the server you use and nothing to do with your setup..
-
I do not think depends on the server.
If you restart the cam before 30 minutes is not blocking takes place.
Always crashes 30 minutes after the start of cccam.
This happens with any server.
I suspect that cccam after 30 minutes is set up to do something that makes block. -
I attach new log
-
Remove everything in the CCcam.cfg so you only have a c line present.. Now CCcam is only configured to read the C line.. If the block happens it`s not how you have CCcam configured.. There would have been an error in the log indicating a block had occurred..
-
The CCcam.cfg file is now empty.
I have included only the cline.
But it was so yesterday.
It always stops after 30 minutes. -
Which version of cccam are you using? Have you tried using MGCamd or OSCam and do these give you the same problem? Also have you tried using a different image such as ViX?
-
master G
Moved the thread from forum Vu+ SOLO2 Support to forum VU+ SOLO 2.
VU+ SOLO 2 PVR Ready Linux Enigma2 Receiver Full HD 1080p
Download VUPlus Images and Enigma2 Team Support from Black Hole, OpenATV, OpenBH, Open Black Hole, OpenDroid, OpenESi, OpenHDF, OpenLD, OpenPLi, OpenSPA, OpenViX, Open Vision, PKT Hyperion, PurE2, SatDreamGR, VTi.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!