There are 4 replies in this Thread which was already clicked 670 times. The last Post () by franco1955.
Dear Experts,
How can I use a c line with Mgcam. I have done some config already with a help of some comments, but it wont work. What Im using a dm500 with PLi image & CCcam 2.1.1 & mgcamd 1.35a installed.
This is because some channels cannot open with cccam & it says CA not supported, so I hope it can open with mgcamd.
Waiting for a prompt reply.
Place the C line into cccamd.list and enable cccamd netclient in mg_cfg (G)..
Hello, you can post an example please. Thank you.
Hello, you can post an example please. Thank you.
# network mode, use summ for several clients
# 00 no network (default)
# 01 newcamd netclient
# 02 radegast netclient
# 04 camd3 netclient
# 08 gbox netclient
# 32 cccamd netclient, card list saved as /tmp/cccamd.info
# (ECM only, supported server version up to 2.1.1, later not work)
G: { 32 }
Thanks Master G, I own a 9500 with xtrend et immagime openxta v2 installed, after installing Mgcamd panel please explain to me better (I'm a beginner) the steps that I have to do to light with a cline.Ciao.
Don’t have an account yet? Register yourself now and be a part of our community!
