Hi guys im pretty new to all of this but here goes nothing
I fancied a little play around with this so i got it from someone
I have acquired a dm800hd clone sim2.10( exact writing on sim is DM800 12105 SIM210) with the dreaded no ca found error
aparently it was flashed with an incorrect image hence why this comes up
Ive tried doing the following using windows xp(32 bit) windows 7 pc 32 and 64 bit edition , also i may add i am using a true serial port NOT USB
ive tried to flash with dreamup ,used dm800 repair tool , used sim repair tool etc , enforcer , basically a million and one tools out there to try and get it to work but no joy as of yet
when i plug it into dreamup it says dm800 detected then does nothing else
ive used a patched version of dreamup to try and upload a file to it (where it enables the flash button), when i select a file it just sits on calculating checksum or sometimes says (file too big)
this is a paste from hyperterminal (plugging in the box )
FIRST STAGE 1.00 {BO23456}
m
2ND STAGE OK, build #75 (20091005)
0.000 - BCM board setup
{00000126,00000126,00000125,00000124,00000123,00000133}
0.007 - fp init
0.008 - ca init
cannot read cert(2)
cannot read cert(2)
cannot read cert(2)
cannot read cert(2)
cannot read cert(2)
CA invalid
OLED found!
NO CONFIGURATION DATA PRESENT. STOP.
* ERR01: NO CA FOUND
ive tried so many ways to get around this and i have had no joy so far
any help would be appreciated as im not convinced its days are over just yet and i do enjoy a little play :))))))