How can you tell what image is installed i have had the box a few days and i think the factory image was on it .
I tried the openvix appllo and boot loader but seems to have loaded quick an do not see any difference hence the question.
The box was bought from WOS board sponsor as was my dark motor,inverto twin lnb plus triax 110TD
Press menu button > Information > About. If it came from the sponsor it probably already has the openvix image on it.
Thanks just checked it has got OPENIMPS 4.0 loaded
Try the Powerboard Enigma VX image. I have it on my older 800se and its a good stable image.
What ever image you look at make sure its the one for your box. If you install an older 800se image on it it will brick it. You have to ensure its the 800se+ image.
Images below i found on the internet, apart from some of them being in Polish they are as you see.
Nano
Nano can't seem to find the Powerboard image for the Gigablue 800se plus.
I have loaded the Openvix image it would not work the first time i tried it friday
Done it last night same file on same usb stick and it worked
Thank you very much M8 registered still waiting for link in my email says it should take about ten minutes my German is rubbbish
Downloaded image and loaded it.
Goes through the process from boot,conf then ok .
Then the powerboard logo comes on the screen the display flashes 25 to 100 then stays on 100 and the red light stays on the panel with the powerboard logo on screen.
reflashed a few times still the same
Powerpard openatv oe alliance and bh of course its your choice bt then
I would try to download it again. The receiver isn't completing the install by the looks of it. I would also try another usb stick.
It should get to 100 then reboot and go into the Enigma setup screen. Download it again and try to reinstall it. If that doesn't work i have no idea what the issue is with your receiver. I have been using Powerboard images since the days of my old dBox2 and can't say i have ever had any issue with any receiver i have installed their images on.
Nano
It was the the image.
After trying to load it i put OPENIMPS 4.1 on it loaded great
The link you mentioned in post 6 i downloaded after registering that was the problem .
This time i downloaded from the site same usb stick loaded great.
Thanks for all your help and advice
Just found out the one in the link is experimental dated gb800seplus-PBNIGMA-VX-3.0-1-20140507_EXPERIMENTAL_usb.zip does not work.
The one that works ok is gigablue_bootloader_gb800seplus_20131102(5).zip. But if i try to update it loads files and reboots and gets stuck on 49% and red strip light stays on .
Just tried updating downloaded updates rebooted by itself stuck on powerboard logo again
Just loaded OPENVIX image it loaded fine so it's not the stb
With openvix i have loaded cam4me-feed-configs_1.0-r0_mipsel.ipk. CCcanm.cfg.
Downloaded cccam 2.31.0 i think is the number.
Put a few a few fictious clines in the CCcam.cfg activated it says cannot connect to webpage.
Not bad for a novice only had the box over week and just tried doing this last night.
Just to find a cline that works .
Thanks for all the tutorials on here i am getting there.
QuoteWith openvix i have loaded cam4me-feed-configs_1.0-r0_mipsel.ipk. CCcanm.cfg.
The cam4me-feed is not for OpenViX image.. For OpenViX image use the softcams from here => ViX Softcams or here => OpenViX Softcam Collection. Softcams without configs can also be downloaded from the plugins menu.
Don’t have an account yet? Register yourself now and be a part of our community!
