Finally bought the original vu solo2 and am very happy.
But I have a problem with my date and time,I changed the timezone but the same problem,any suggestions!?
Best wishes to all.
Vu+ Solo2 ORIGINAL
- kingu
- Thread is marked as Resolved.
-
I suggest you use a third party rather image than the factory firmware.. BlackHole or OpenViX would be a good place to start buddy..
-
The time and date usually looks that way when you have no signal, like there is no cable connected to the tuner or tuner hasn`t been configured properly.
How do you have your tuner setup and for what satellites ?
Are you able to view any channels ?
-
In timezone setting change the sync time from transponder to NTP, the time will then be set via the internet instead of transponder feed..
-
The image/option i showed was from openViX, if VTI doesn`t have this option try this => Set date, time and timezone
-
master G
Moved the thread from forum Vu+ SOLO2 Support to forum VU+ SOLO 2.
VU+ SOLO 2 PVR Ready Linux Enigma2 Receiver Full HD 1080p
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!
