idiot guide to reflash

There is 1 reply in this Thread which was already clicked 1,020 times. The last Post () by tomthered.

    need help to reflash nbox 5800/sx n-fbox n-hyperion usb3 usb2 usb1 ush1 env2 bsla+hdd fb-uboot n-nebula updt which do i use to reflash from graterlia openpli that is not loading anymore after changing a setting on epg and applying judder fix cheers dazzza and which is most stable image

    I would have gone for Hyperion 4. Its based on Openpli like Graterlia but is much easier to use. Your reflash depends on where it is going to. Into Nand you will need to start from scratch, otherwise its a case of burning the image from within the Blue Panel onto USB or Hard drive. If its usb you will see sdb1 in Install Manager at the top. At the bottom you need to search for your image which you will have transferred to the box by ftp. DCC will allow you to do this. Once you have set up what you want just choose install and wait untiul finished then reboot into USB1 and it should boot up for you. Once done make a backup of how you have set it up in case it goes wrong in the future, its easier to reinstall.

Firmware, downloads and support for nBox 5800S / SX HDTV.

Your community resource for the nBox 5800S / SX HDTV satellite receiver — firmware images, channel lists, plugins and setup help.