[DOWNLOAD] Oscam Build For BlackHole PrismCube 2.0.0 and below
- faroukn91
- Thread is marked as Resolved.
-
-
-
-
-
Oscam-120r9856 PrismCube bhp.tgz
-
Oscam-120r9857 PrismCube bhp.tgz
-
Oscam-120r9859 PrismCube bhp.tgz
-
Oscam-120r9860 PrismCube bhp.tgz
-
Oscam-120r9861 PrismCube bhp.tgz
-
Oscam-120r9862 PrismCube bhp.tgz
-
Oscam-120r9863 PrismCube bhp.tgz
-
Oscam-120r9864 PrismCube bhp.tgz
-
Oscam-120r9865 PrismCube bhp.tgz
-
im running prismcube bh image 1.7.7 with 1.20-r8943 .,
my cline just expired which was working fine.
since getting new cline (different supplier) and converting to oscam
this is freezing very badly ,do I need to update my oscam ? if so which version should I install?.
sorry if in wrong section, if it is please accept my appolgies and move to the correct place -
im running prismcube bh image 1.7.7 with 1.20-r8943 .,
my cline just expired which was working fine.
since getting new cline (different supplier) and converting to oscam
this is freezing very badly ,do I need to update my oscam ? if so which version should I install?.
sorry if in wrong section, if it is please accept my appolgies and move to the correct place
sounds like you new line is not good us old one (if that you used same oscam old line working fine but new line not working)maybe try latest oscam see if works or try your new line with different box see if works better then you get some idia -
im running prismcube bh image 1.7.7 with 1.20-r8943 .,
my cline just expired which was working fine.
since getting new cline (different supplier) and converting to oscam
this is freezing very badlyclines from peers don't expire, only lines from a payserver do buddy........ please read the forum rules regards asking for support if your using a payserver.
-
Oscam-120r9866 PrismCube bhp.tgz
-
Oscam-120r9867 PrismCube bhp.tgz
-
Oscam-120r9868 PrismCube bhp.tgz
-
clines from peers don't expire, only lines from a payserver do buddy........ please read the forum rules regards asking for support if your using a payserver.
please accept my apololgies, as I no nothing about peers . it is a lot better now. would I actually benefit updating oscam from1.20-r8943 to the latest 1.20r9868 as I don't wanna upset out,
please delete all my post I have just re-read rules and wouldn't like t be banned from this great site . again very sorry for my ignorance
-
master G
Moved the thread from forum PrismCube Ruby Softcams to forum PrismCube Ruby Images. -
master G
Moved the thread from forum PrismCube Ruby Images to forum PrismCube Ruby.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!