How do I enter Boxkey in MGCAMD v1.35a

There is 1 reply in this Thread which was already clicked 550 times. The last Post () by mckee25.

    Hi and thanks in advance for any help and assistance.


    I am trying to use my original $ly card in my receiver, however it does not seem to be working as it just uses my suppliers source line.


    My setup is a Technomate TM-Nano2 Super using OpenPLi 3.9.7 20140829 and I am using MGCAMD v1.35a and CWS lines.


    Could someone please explain how I should setup mg_cfg and the newcamd.list files so that it reads the card first rather than the servers ?


    I already have my boxkey to hand.


    Thanks in advance.


    Timbo

MGCamd Support Forum

Configs, discussion, downloads and guides for MGCamd Softcam.

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!

Register Yourself Login