My converted line did not appear to work, and while looking around the folders etc, I deleted the contents inside the conf file.
Whats the best thing to do please ?
Deleted contents of Oscam.conf...please help
-
- SH4 Spark OSCam
- FrancisG
- Thread is marked as Resolved.
There are 7 replies in this Thread which was already clicked 774 times. The last Post () by nano.
-
-
What is your setup? local card or line?
This handy tool will set up your config file again if it is only a line you are working from:
http://linuxsat-support.com/showthread.php?t=2569
Enter your details (c / n line) into top of tool and make sure oscam server is selected in bottom of tool.
Click convert and copy all that has been produced into your oscam server file.
This is only for a line. For a card, there is a little bit more to setup.
Here are a full set of configs for an 0963 card:
http://linuxsat-support.com/showthread.php?t=3271 -
Thanks...my issue is within the the oscam folder, just the actual details of the oscam.conf, when you right click to see the details...they are now blank
-
Use the attached oscam.conf and oscam.user files, you can continue to use your own oscam.server file.
-
Thanks..ill give that a go. Bit afraid to try things but learning lots from you guys
- - - Updated - - -
Use the attached oscam.conf and oscam.user files, you can continue to use your own oscam.server file.
Will I just find the 2 file in the /keys folder and replace
-
Overwrite the oscam files that are in /usr/keys folder with the files i attached and your oscam.server file..
-
Swooped the two oscam files, but still can't get the converted cline to work. Need to study the whole oscam thing further
-
C: linedns.com 12000 user pass no { 0:0:2 }
Converts to this in oscam.server
[reader]
label = C Line 1
protocol = cccam
device = linedns.com,12000
user = user
password = pass
inactivitytimeout = 1
reconnecttimeout = 10
group = 1
cccversion = 2.3.0
cccmaxhops = 2
ccckeepalive = 1Works fine for me. If you copy the oscam line above and then paste your c line into it as shown by the colours.
Make sure that you set the correct group in oscam.user as shown in bold and blue. see the example below.
[account]
user = dvbapi
pwd = local
monlevel = 4
au = 1
group = 1Nano
OSCam Support Forum
Configs, discussion, downloads and guides for OSCam Softcam.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!