Mgcamd 138

There are 5 replies in this Thread which was already clicked 1,598 times. The last Post () by rasp.

    I have installed Mgcamd 1.38 on my VU slolo2 in var keys this is what i have.


    ccamd.list
    Mfg.cfg
    Newcamd.list.


    Put the clines in ccamd. list and cws in newcamd.list


    I have stopped cccam 2.3.0 in cam manager.

    I updated the vix image online yesterday


    Start Mgcamd in softcam manager works ok for ten minutes then switches it self off and starts CCcam again



    Restart Mgcamd and disable automatic startup for Cccam but same thing happens


    What am i doing wrong

    I am not an expert in this - i'm very new and still learning myself, but perhaps you should try removing CCcam? If it's not there, it can't start up?


    Again - I'm completely new to this; so my suggestion is from a completely uneducated viewpoint(!!)

    You will need to put a N:line into MG cam cfg >>>>
    Not sure which one though

    78cm dish on tm2300 metal gear motor + 1m Orb with tm2300 + 1.8m Channel Master on H-H floor mount + 80cm ISS with TM2300 AND Inverto Black LNB,inverto Unicable QUDL 42 LNB,- Global invacom Dscc LNB,- Triax KA LNB, - Yuri LNBF C Band YLF-CDP16C

MGCamd Support Forum

Configs, discussion, downloads and guides for MGCamd Softcam.

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!

Register Yourself Login