Im new to this and have a DM500s with commando 14.6 on it. I cannot seam to find anywhere where I can see the signal strength for when I set my satellite dish up. Thanks in advance
Signal Strength
- kingchristo
- Thread is marked as Resolved.
There are 7 replies in this Thread which was already clicked 789 times. The last Post () by kingchristo.
-
-
When and if the dish is installed right it wont matter you should
consider changing to a newer flash (IMAGE) some of your
channels might not work -
Can you recommend a newer or better image thanks
-
you could buy a sat finder, I've just done mine with one i bought brand new for 12 quid, i found it very accurate
-
ya im thinking of getting one and just checking the dish out im also thinking of putting commando 15 on it
-
I would wait till all is ok with the dish first
have you got an rs232 lead and a serial port will be needed
if the flash does not work right, have you dcc, or filezilla installed on pc
as you should be able to send image to temp and use remote to
upgrade image LOL -
Well ive tried the dish today and the strange thing is when I put the meter on and but my box on a channel that works its fine on the meter but when I put on a channel that's signal is week like bbc the meter shoots up to the top of the slace and wont go back down carnt work this out?
-
Does commando 15 have a signal strength page
-
master G
Moved the thread from forum DM500 - DM500s Support to forum Enigma1 Support.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!