Hi i have a dark motor with 85cm dish and when i press the goto 0 on the above TM 6902 reciever all my channels are lost and a red bar shows up with a low signal indicator. However i have recently managed to force using the satelite setup and motorized settings my channels back on with a scan. If i where to press the goto position 0 again i know i will lose everything. Can anyone tell me what is happening and why ?
Thanks.
Technomate 6902 HD goto position 0 selection.
- johnt
- Thread is marked as Resolved.
Master your satellite setup with expert installation support.
Get dish alignment help, LNB guidance, and configuration tips for single, multi, and motorized systems. Your technical forum for satellite installation. Get support for LNBs, DiSEqC switches, motorized systems, actuators, and dish alignment for any setup.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!
